-
Position the BAMBINO on the surface point to be tested, perpendicular to the surface.
-
Arm the impact device – slide the actuator towards the housing. The catch chuck grasps the impact body and draws it against the energy spring to a defined force. This motion “wakes up” the electronics and the display shows the current test settings.
-
Test is accomplished by again sliding the actuator towards the housing. This releases the impact body from the catch chuck and propels it towards the test surface within the defined energy. Results are immediately displayed in the selected scale. No separate trigger action is necessary – loading and release is accomplished in the same motion. Better than ISO N7. Excessive scattering of test result indicates poor surface preparation.
Configuring the EQUOTIP Bambino
|
The display output of your test results (scale and material) can be configured individually by the 3 button on-board control system or via the PC interface program. Basic statistic option, <cancel> for last test value and check of hardware features make the Bambino ready for maximum ease of customized use. Sensing and compensation for impact direction is default, but can also be switched off.
|
|
