The Advantages of the MultiScanner Pro SL
Uses a patented sensor to pinpoint the edges of wood or metal studs behind walls, floors, or ceilings.
-
Turn off wood and metal scan to look only for hot AC to find and trace wires, even in plastic conduit.
-
Metal Scan finds rebar in concrete up to 76 mm deep and concrete pipe or metal conduit up to 38 mm deep behind walls, floors, and ceilings
-
Easy-to-understand, on-screen graphics and audio signal indicate target edges
-
Exclusive, patented SpotLite Pointing System shines a bright beam of light over target edges.
Technical Information
| Dimensions : |
162 mm x 78 mm x 34 mm |
| |
|
| Weight : |
184 g without battery |
| |
|
| Battery type : |
9-V alkaline (not included) |
| |
|
|
| Position accuracy : |
Stud Scan mode: |
typically within 3 mm using the dual scan and mark procedure |
|
|
|
| |
DeepScan mode: |
typically within 5 mm using the same procedure |
|
|
|
| |
Metal Scan mode: |
typically within 13 mm |
| |
|
| Depth : |
Up 19 mm in Stud Scan mode |
| |
Up to 8 mm in Deep Scan mode |
| |
Up to 38 mm for copper in Metal Scan mode |
| |
Up to 76 mm for rebar in Metal Scan mode |
NOTE: Sensing depth and edge detection can vary due to moisture content of materials, wall texture, paint, etc.
AC position accuracy Typically 90-250 Vat 50-60 Hz laterally within 150 mm of a hot unshielded wire
AC depth Typical depth of 50 mm
| Operating temperature : |
7° to 49° |
| |
|
| Storage temperature : |
29° to 66°C |
| |
|
| Humidity : |
80% RH (non-condensing) |
| |
|
| Water resistance : |
Splash and water resistant, but not waterproof |
|
